Overrunning Clutches & Backstops


Stieber Clutch NF Type

Type NF is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation.

Standard lubrication is oil. Nominal outside diameter is a standard ball bearing dimension. A typical arrangement is to install this type alongside a bearing with the same housing tolerances, as shown on the following page. The inner race is keyed to the shaft. The outer race has a positive n6 tolerance to give a press fit in a H7* housing. Additional side notches provide for positive torque transmission.

If the housing tolerance is to K6*, use of the notches is not necessary, but the housing must be strong enough to not expand after assembly.

*These data refer to the indications in the product data sheet attached below (on page 2).

    Hatschekstraße 36
    69126 Heidelberg - Germany
    Phone:+49 6221 3047-0
    Fax:+49 6221 3047-31
    Web: Contact
Cookies help us improve your website experience.
By using our website, you agree to our use of cookies.